Page 1 of 1

2017 update what you like/don't like

PostPosted: Fri Apr 14, 2017 2:30 pm
by mastoy
G'mornin folks, been a long time lurking and learning here and have always enjoyed.
I am looking at a new sleep system, possibly with HST included. Reviewed the posts from the past and most are more than a couple years old, so I'm asking what y'all think is good going foward. Have been using Rembrandt sinse @ 2000 and liked it a lot until our last update. I would appreciate anyones opinion and experience with recently new systems they are using.

Re: 2017 update what you like/don't like

PostPosted: Wed Jun 07, 2017 6:14 am
by RayMeece
We use the Respironics Alice 6 with the Sleepware G3 system. It is user-friendly, with customizable repots, and also use their Alice NightOne HST units. I highly recommend it.

Re: 2017 update what you like/don't like

PostPosted: Tue Jun 20, 2017 2:13 pm
by mastoy
Thanks for the response Ray. Alice seems to be pretty popular so I guess I'll be calling "M" soon.

Re: 2017 update what you like/don't like

PostPosted: Thu Jun 22, 2017 6:16 am
by stars
Alice 6 big BS very propriety set up montage big pain
if you have respironics cpap and resmed need different montage
same with etco2 and tco2 cant be in one montage
Same with score
I badly dream about compumedics.

Re: 2017 update what you like/don't like

PostPosted: Fri Jun 23, 2017 12:36 pm
by RayMeece
stars wrote:Alice 6 big BS very propriety set up montage big pain
if you have respironics cpap and resmed need different montage
same with etco2 and tco2 cant be in one montage
Same with score
I badly dream about compumedics.


Sorry, my English is not that good - I don't understand. I have used Respironics for years, and have seen nothing about what you are referring to. Can you explain a little further?

Re: 2017 update what you like/don't like

PostPosted: Fri Jun 23, 2017 1:12 pm
by stars
1 need separated application for Resmed and Respironics titration system
2 need separated montage for montage etco2 and tco2
3 we had Compumedics before and had one universal montage
4 very poor Mark desaturation and arousal mostly with rera
Very hard created report and data with asv
We try much better sensor to flow
and I can receive good signal
Vs with same sensor I try with 3 another system
Same problem with seizure montage for Resmed room. And Respironics room we have two titration
System
This just for start

Re: 2017 update what you like/don't like

PostPosted: Mon Jun 26, 2017 2:28 am
by RayMeece
Well, that's a lot. I guess we don't have issues because we use Respironics equipment, no TcO2 or no etO2, whatever.

I lke it, it is easy to use and easy to correct their reports, to some degree. And they have some free report generation service initially.